Cleaning And Maintenance; Troubleshooting - Küppersbusch CSV6800.0 Bedienungsanweisung Mit Montageanweisungen


The cycle ends when the symbol
switches off.
CONDITIONING PROGRAM
This program must be used in the following
situations:

Before using the machine for the first
time.

After a long stop period.

After having sealed products with high
humidity content (e.g. soups).

When you notice
performance of the machine (e.g.: time to
reach vacuum is increased or it does not
reach it at all).
This program lasts about 15 minutes and
ensures a complete cleaning of the pump,

Clean the appliance after use.

Clean the Plexiglas cover (6) inside and
out using only neutral detergents (water
and soap).

Do not use abrasive products, alcohol-
based detergents, abrasive sponges,
solvents or metal objects. Follow the
safety instructions indicated on the
packaging, in the event you use sprays.

Clean the sealing bar (1) using a dry
cloth. Remove any film residue that
deposits on the bar.

Before cleaning the tank (5), especially
when liquid
Problem
The pouch is not
sealed correctly
a decrease
remains are in,
Cause
 The sealing time is not correct.
 The cover gasket is dirty or worn.
 The pouch is not placed correctly
on the sealing bar.
 The sealing bar is worn (the Teflon
coating is burnt).
removing any liquid emulsion that might be
found in the oil. Do not seal any product
while this program is running.
This program has no set variables.
Follow the indications below to start the
program:

Hold down the
buttons flash.

Close the cover with light pressure.

Press the
conditioning cycle.

in
At the end of the cycle (15 minutes) the
machine will be ready for use.
Note: The Conditioning Program should be
used at least once per month.
recommended to remove the sealing bar
(1).

Clean the metal surfaces using normal
detergents suitable for stainless steel.
it is
 Change the sealing time.
 Clean or replace the cover gasket (contact the
Technical Assistance Service for a
replacement).
 Position the pouch correctly.
 Replace the sealing bar (contact the Technical
Assistance Service for a replacement).
button until all the
button to start the
Solution