Herunterladen Inhalt Inhalt Diese Seite drucken

The Excessive Accumulation Of Grease In The Hood And Metal Filters May - Küppersbusch DI 3800.0 S Bedienungsanweisung Mit Montageanweisungen

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Dear Customer,
Congratulations on your choice. We are certain
that this modern, functional and practical device
made with first rate quality materials will fully
satisfy your requirements.
Please
read
all
INSTRUCTION MANUAL before using the hood
for the first time in order to obtain maximum
performance from the device and avoid faults
which may arise from incorrect use as well as
minor problem solving.
For optimal performance, the external duct
should not exceed FOUR METRES, have more
than two 90 ° angles and its diameter should be
at least Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the
interior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
grease in the hood and metal
filters
may
and fire risks, therefore it is
necessary to wash the inside of
the hood and the metal filters at
least once a month.
•This device can be used by
children aged 8 and over and
persons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge, if they have been
given supervision or proper
training in the safe use of the
device and if they understand
the dangers involved. Children
should not play with the device.
Cleaning
and
should be performed by the
the
sections
in
cause
dripping
maintenance
user and not by unsupervised
children.
•Check that the power voltage
and frequency match those
this
indicated on the label located on
the inside of the hood. A suitable
earth must be connected (except
for Class II devices, marked with
on the technical data plate).
•For installation, a connection
method
fixed installation should be
incorporated, in accordance
with
installation
(adjusted to the strength to be
endured and with a minimum
opening between the contacts
of 3mm) under overvoltage
category III conditions, for the
emergency shutdown, cleaning
or light replacement. In no event
should the earth pass through
this switch. This switch can
be replaced with a plug if it is
accessible in normal use.
•If the power lead is damaged
it must be replaced by the
manufacturer, its after-sales
service or by qualified personnel
in order to avoid potential danger.
•Air should not be extracted by
ducts used to expel fumes from
equipment powered by gas or
other fuels.
•The room must be adequately
ventilated when the hood will
be used simultaneously with
isolated
from
regulations
the

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Di 3800.0 wDi 3800.0 g

Inhaltsverzeichnis