System Menu; Information Menu; Maintenance Menu; System Information - Kessel INNO-CLEAN+ Anleitung Für Einbau, Bedienung Und Wartung

8.1.System menu

Information
Informationen
Systeminfo

System Information

Time: 00:00:00
Uhrzeit: 00:00:00
Floater: On/Off
Schwimmer 1: Ein / Aus Maintenance Wartung
TX: Phase T1 - T24
TX: (Phase T1 bis T24)
TX1: (time: 00:00:00)
TX1: (Zeit: 00:00:00)
Positions
Einstellungen
0
Time:
Floater:
T1 Feeding
TX1< 00:05:54 Feeding

8.2 Information menu

Information
Informationen
Systeminfo
Systeminfo Informationen
System Information
Time: 00:00:00
Uhrzeit: 00:00:00
Uhrzeit: 00:00:00
Floater: On/Off
Schwimmer 1: Ein / Aus
Schwimmer 1: Ein / Aus Wartung
Maintenance Wartung
TX: Phase T1 - T24
TX: (Phase T1 bis T24)
TX: (Phase T1 bis T24)
TX1: (time: 00:00:00)
TX1: (Zeit: 00:00:00)
TX1: (Zeit: 00:00:00)
Positions
Einstellungen
Einstellungen

8.3 Maintenance menu

Systeminfo
System Informationen
Information
Information
Wartung
Maintenance
Positions Einstellungen
8. Control of the septic system
B
System Information
Attendend time
Betriebsstunden
B
Events/Errors
Ereignisse / Fehler
Steuerungstyp
Command type
Maintenance Date
Wartungstermin
Water level
Wasserhöhe
Parameter
Parameter
man. operation
Handbetrieb
Testbetrieb
test operation
Wartungstermin
Maintenance Date
117
Display of the hierarchy level
Time
Display of the activated floaters and their position
Display of the phase
Display of the currently expired time of the respective phase
Display of alarm/fault information
G
8.2.2 Incidents / faults
Display of chronological faults and incidents (see also
chapter 10 "Malfunctions and remedial measures")
All changes made to the settings are saved at this point.
8.2.3 Control type
Display of purification class, size, language and software
version
8.2.4 Maintenance deadline
Display of the next necessary and last performed main-
tenance
Note: Data are only available if these have been stored
in the menu "Settings" by the maintenance partner. (see
also 8.3.3)
8.2.5 Water level
Pressing the OK key carries out a measurement of the
current water level in the aeration basin.
8.2.6 Parameters
Display of all set control parameters of the plant. Chan-
ging the parameters is not possible in this menu (see also
8.4.1 and 8.4.2)
8.3.1 Manual operation
Manual operation overrides automatic operation. Ma-
nual activation of the ventilation plate lifters and of the
aerator spark plug.
8.3.2 Test operation
Automatic test of the valves in the valve block. The com-
pressor is not switched on during this process.