Configuration - CareFusion Micro I Bedienungsanleitung

Configuration

When the unit is first turned on it may be configured for your region.
This will set the language, height and weight units, date format and
predicted values set appropriate for your region. It will also configure
the indices to be displayed and whether percentage predicted or Z-
score is to be used to show variation from the norm. However all of
these settings may be customised using the PC software supplied.
Turn the unit on by pressing the on/off button located at the top of
the device and the following will be displayed:
Use the up and down arrow keys to highlight the required country and
then press 'Enter' (). This procedure is only required when the unit
is first switched on and the selection will be stored for future use.
It is recommended that the PC software be used to adjust these
settings, if required. Connect Micro I to the PC using the USB cable
supplied. Run the software, and turn on the Micro I. The PC software
will detect that the Micro I is connected. Follow the on-screen
instructions to configure your unit.
14