Troubleshooting - Digital Projection HL12000Dsx+ Bedienungsanleitung

2. Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.
Power Indicator
Indicator Condition
Blinking light Green blinking
Orange blinking
Green
Steady light
Orange
Status Indicator
Indicator Condition
Blinking light Red blinking
Steady light Red
Orange
Green
Please ask your delivery outlets to handle the error codes.
Error No. Error Messages
0001
Cover Open
0002
Lamp Data
0003
Lamp Time Over
0004
FPGA JOE2P
FPGA JOE2S
FPGA DVIOUT
FPGA WARPSEL
FPGA WARP
FPGA DVI1
FPGA DVI2
FPGA DVI3
FPGA DVI4
FPGA SDI1
FPGA SDI2
FPGA SDI3
FPGA SDI4
FPGA SLOTSEL
FPGA OSD
Off
0.5 sec ON,
0.5 sec OFF
2.5 sec ON,
0.5 sec OFF
0.5 sec ON,
0.5 sec OFF
2.5 sec ON,
0.5 sec OFF
Off
1 cycle (0.5 sec ON,
2.5 sec OFF)
2 cycle (0.5 sec ON,
0.5 sec OFF)
3 cycle (0.5 sec ON,
0.5 sec OFF)
4 cycle (0.5 sec ON,
0.5 sec OFF)
6 cycle (0.5 sec ON,
0.5 sec OFF)
Description
Cover open orTIMER
PWB contact failure
Malfunction on lamp data
Lamp time over (power-off)
FPGA configuration error
Projector Condition
The main power is off
The projector is getting ready to turn on.
The lens shutter is closed.
Off Timer or Sleep Timer is active.
The projector is cooling down.
On Timer is active.
The projector is turned on.
The projector is in Standby.
Projector Condition
Normal
Lens hood or lamp cover error
Temperature error
Power error
Fan error
Lamp error
Circuit error
Control key locked
Idle condition
Error No.
0005 Set Temp.
0006 Fan Stop
0007 Lamp PS Temp.
0008 Lamp Temp.
0009 Lamp Off
0010 DMD Status
0011 DMD Temp.
0012 Lamp Fan Stop
0013 Pump Stop
0014 Power Supply
0015 Lamp Time Warn
10
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
–
Note
–
Replace the lens hood or the lamp cover
correctly.
The projector is overheated. Move the
projector to a cooler location.
Power unit will not work correctly.
Cooling fan has stopped. Contact your
dealer.
Lamp fails to light. Wait 3 minutes and
then turn on again.
An error occurs in the circuit. Consult
your dealer.
You have pressed control panel key when
Control Key Lock is enabled.
–
Error Messages
Temprature malfunction
in internal set
Fan stop
Temprature malfunction
on Lamp PS
Temprature malfunction
on Lamp
No lamp lighting
DMD malfunction
DMD temprature malfunc-
tion
Lamp fan stop
Pump stop malfunction
Power supply mulfunction
Lamp time over (warning)
Description