Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
cleaning informations
Surfaces
The most common coating of a sanitary fitting is the
chrome-nickel surface finish according to DIN EN248,
which is also used as surface materials such as stainless
steel, plastics including powder and wet paint, ano-
dised aluminium and galvanised surfaces.
Coloured, non-metallic surfaces are generally more
sensitive than metallic surfaces, especially against
scratches. Therefore, it is absolutely essential to deter-
mine the type of surface to be cleaned before cleaning.
General information on cleaning and care of sani-
tary fittings and accessories
In order to meet the market needs in terms of design
and functionality, modern sanitary products today con-
sist of very different materials and thus place different
demands on the cleaning agents and their ingredients
used.
cleaning agents and tools
Acids are indispensable as a component of cleaning
agents for the removal of lime deposits.
However, in the case of sanitary products, it should be
noted that
•
only the cleaning agents intended for the area of
application are used.
•
Do not use cleaners containing hydrochloric acid,
formic acid or acetic acid, as they can cause con-
siderable damage even after a single application.
•
Phosphoric acid cleaning agents are not fully ap-
plicable.
•
Do not use detergents containing chlorine bleach.
•
the mixing of cleaning agents is generally not per-
mitted.
•
use of abrasive cleaning agents and equipment,
such as unsuitable scouring agents and pad spong-
es, may cause damage.
•
preferably cleaning textiles are used which bind as
few particles as possible.
(Woven fabrics are more suitable than woven.)
CONTI Sanitärarmaturen GmbH, Hauptstraße 98, 35435 Wettenberg | Telefon: +49 641 98221 0 | Fax: +49 641 98221 50 | info@conti.plus
www.conti.plus | Artikelnummer CONDOK0010011 | 04/2019 | Druckfehler und Irrtümer sowie technische und maßliche Änderungen vorbehalten
Tip
Residues of body care products can also cause dam-
age and must be rinsed off immediately after using the
fittings and accessories with clear, cold water without
leaving any residue. Damage to surfaces that have al-
ready been damaged will progress as a result of the
action of cleaning agents.
Recommendations for cleaning and care
The instructions for use issued by the cleaning agent
manufacturers must be strictly followed.
Generally, it should be noted that
•
cleaning must be carried out as required.
•
the detergent dosage and duration of action must
be adapted to the object-specific requirements
and the detergent must never be allowed to work
longer than necessary.
•
the build-up of calcification must be prevented by
regular cleaning. Water droplets should therefore
be wiped off with a soft cloth or chamois leather
after use.
•
any limescale deposits must be removed by direct
application of detergent if necessary.
•
in the case of spray cleaning, do not spray the
cleaning solution on the sanitary fittings and
acces sories, but on the cleaning textile (cloth/
sponge) and thus the cleaning is to be carried out,
as the spray mist can penetrate into openings
and cracks etc. of the fitting and accessories and
cause damage.
•
Wash cleaning textiles as often and thoroughly as
possible so that only clean cleaning textiles with-
out foreign particles are used. Particles deposited
in cleaning textiles can lead to scratches and dam-
age to surfaces.
•
after cleaning, rinse thoroughly with clear water to
remove any remaining product buildup.
surface protection
Lacquered and galvanized surfaces should be provided
with a thin protective film on a regular basis. The use
of a preservative specially formulated for lacquered or
galvanised surfaces is recommended.
11
Werbung
Inhaltsverzeichnis
