Klarstein Amazonia 6 10028325 Bedienungsanleitung Seite 39

Fill the Rinse Aid Dispenser
The rinse aid is released during the final rinse to prevent water from forming droplets on
your dishes. That can leave spots and streaks. It also improves drying by allowing water
to sheet off the dishes. Your dishwasher is designed to use liquid rinse aids. The rinse aid
dispenser is located inside the door next to the detergent dispenser. To fill the dispenser,
open the cap and pour the rinse aid into the dispenser until the level indicator turns
completely black. The volume of the rinse aid container is about 1 10 ml.
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and
spot and streak free drying. Rinse aid is automatically added during the last rinse,
ensuring thorough rinsing, and spot and streak free drying. Only use branded rinse
aid for dishwasher. Never fill the rinse aid dispenser with any other substances (e.g.
Dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Refill Rinse Aid Dispenser
If there is no rinse-aid warning light in the control
panel, you can judge the amount of rinse-aid by the
colour of the optical level indicator located next to the
cap. When the rinse-aid container is full, the whole
indicator will be dark .As the rinse-aid diminishes, the
size of the dark dot decreases. You should never let the
rinse aid get below 1 / 4 full.
1 To open the dispenser, turn the cap to the „open" (left) arrow and lift it out.
2 Pour the rinse aid into the dispenser, being careful not to overfill.
3 Replace the cap by inserting it aligned with „open" arrow and turning it to the
closed (right) arrow.
Note: Clean up any rinse aid split during filling with an absorbent cloth to avoid
excessive foaming during the next wash. Don't forget to replace the cap before you
close dishwasher door.
EN
39