Klarstein Amazonia 6 10028325 Bedienungsanleitung Seite 38

EN
38
Note: The salt container must only be refilled when the salt warning light in the control
panel comes on. De- pending on how fully the salt dissolves, the salt warning light
may still be on even though the salt container is filled. If there are spills of the salt, a
soak or a rapid program should be run to remove the excess salt.
Adjusting Salt Consumption
Close the door, within 60 seconds after power on, press Start/Pause button and hold
for 5 seconds, the machine will enter setting mode.
Press the Start/pause button to select the proper set according to your local environment,
the sets will change in the following sequence: H1 > H2 > H3 > H4 > H5 > H6.
There are 6 levels of salt consumption in all. It is recommended to select the level
according to below table:
Water hardness level
°dH mmol/l
1
0-5 0-0.9
6-1 1 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.1
35-45 6.2-8.0
¹ German degree of measurement for the water hardness
² International unit for water hardness
Factory setting
*
Note: Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
Setting on the
water softener
2
1
2
3
4
*
5
6
Digital Display stalls
H1
H2
H3
H4
H5
H6