Sirona inLab MC XL Ergänzung Zur Gebrauchsanweisung Seite 23

Sirona Dental Systems GmbH
Supplement to Operating Instructions
63 22 346 D 3493
D 3493.201.05.03.02 08.2011
WARNING
Risk of injury on the remainder of the ceramic block
The remaining portion of the ceramic block may have sharp edges
(e.g. A) that could injure you if it is not removed carefully.
Always grasp the remainder of the ceramic block by its metal holder.
11. Loosen the ball pressure screw.
12. Remove the remainder of the ceramic block. When removing the
remaining block from blocks with 6 mm diameter block holders, make
sure that the adapter sleeve remains in the machine!
13. Close the milling chamber door.
Defective milling results
CAUTION
Do not use defective milling results!
Milling results must be judged by the user (dentist or dental technician)
and must not be used if defects are detected!
Removing chips
NOTICE
Chips gathered in the milling chamber
When milling models, a large number of chips collect in the milling
chamber.
➢ Each time a model block is milled, remove the chips from the milling
chamber by hand.
➢ Before removing them, squeeze the chips so that any stored water
is released into the cooling circuit.
Open the milling chamber door
NOTICE
If you have not used the milling unit for a rather long time, we
recommend you should switch it off and then open the milling chamber
door so that the milling chamber can dry out.
4 Starting the milling process
9