Starting The Milling Process - Sirona inLab MC XL Ergänzung Zur Gebrauchsanweisung

Sirona Dental Systems GmbH
Supplement to Operating Instructions
63 22 346 D 3493
D 3493.201.05.03.02 08.2011
4

Starting the milling process

Information on milling models Starting the milling process
IMPORTANT
Models can only be milled using inLab 3D Stack software.
Preparations
✔
Load or design a restoration (see Operator's Manual, chapter on
"Design").
1. Start the milling process by clicking the
2. If several milling units are connected, a dialog box will appear. Select
the milling unit you prefer and confirm your choice with
3. Select the milling instruments if necessary. An overview table of the
milling instruments and the materials that can be milled using them is
provided in "Overview of materials and milling instruments".
Starting the milling process
CAUTION when using milling cutters
NOTICE
Make sure the correct tools are used
Specific tools (milling cutters) are required for milling the models on the
inLab MC XL. The milling cutters will be used as follows:
Set 1: Finisher 10
Set 2: Shaper 25
➢ Do not use the milling instruments for restorations in order to
produce models.
CAUTION when using milling cutters
NOTICE
Make sure the milling cutters are used correctly
If the milling cutters are not used as described below, this may cause
damage to the milling unit.
➢ Use the Shaper 25 and Finisher 10 milling cutters only in inLab MC
XL milling units, as of serial number 120 000 or in inLab XL milling
units that have been upgraded using the motor upgrade kit for inLab
(REF 6338631).
➢ Use the Shaper 25 and Finisher 10 milling cutters only for
manufacturing models from the inCoris S model (REF 6299361) and
inCoris L model blocks (REF 6299379).
4 Starting the milling process
"Mill"
icon.
"OK"
.
7