Connecting The Barcode Reader - Sirona inLab MC XL Ergänzung Zur Gebrauchsanweisung

2 Connecting the barcode reader

4
2
Connecting the barcode reader
Connecting the barcode reader
Units with serial numbers < 115 160
NOTICE
For inLab MC XL units with serial numbers < 115 160, a new unit rear
panel (REF 61 48 758) must be installed.
➢ Replace the rear panel.
Loosen the Torx screws and remove the rear panel. Use the rear
panel provided and secure it in place with Torx screws.
Connecting the barcode reader
1. Plug the adapter onto the serial interface to the rear of the milling unit
and secure with screws.
2. Plug the adapter onto the barcode reader.
3. Connect the power supply unit to the voltage supply.
Attaching the tool holder
Sirona Dental Systems GmbH
Supplement to Operating Instructions
63 22 346 D 3493
D 3493.201.05.03.02 08.2011