512 Adjusting The Volume; 513 Setting The Squelch - Monacor PAS-254D Bedienungsanleitung

2) Select the channel for receiver section A with
the button  or  and then confirm with
the button SET .
3) The channel indication for receiver section B
starts flashing on the display . Select the chan-
nel for receiver section B with the button 
or  and then confirm with the button SET .
When only one receiver section A or B is
switched on:
Keep the button SET pressed until the channel
indication starts flashing on the display . Select
the channel with the button  or  and then
confirm with the button SET .
Notes:
1 . The receiver sections cannot be set to the same
channel .
2 . If a channel is not confirmed within 10 seconds with
the button SET, the setting mode will be exited and
the channel previously set will be kept .
3 . If, with the transmitter switched off, the respective
segment bar A or B on the display indicates reception,
interference signals or signals from other transmitters
are being received . In this case, use a different channel .
5.1.2 Adjusting the volume
Switch the wireless microphones / transmitters
on and set one to the channel of receiver sec-
tion A and the other to the channel of receiver
section B . The respective segment bars on the
display will then indicate the strength of the
radio signals received . Use the controls to adjust
the desired volume for each receiver section .
Use the control 2 WIRELESS (7) to adjust the
volume of the audio signals received .
Note: If no signal is received from the wireless micro-
phone, make sure that the microphone transmits on the
correct frequency (channel) and check the battery of the
microphone . If required, reduce the distance between the
amplifier system and the microphone .
5.1.3 Setting the squelch
The squelch function will mute the respective re-
ceiver section when the level of the radio signal
falls below the threshold value adjusted . Thus,
interference signals will not cause noise when
the transmitter is switched off or when its radio
signal is poor: If the levels of the interference
signals are below the threshold value, the re-
ceiver section will be muted . A high threshold
value offers high interference resistance, but it
will also reduce the transmission range .
1) Switch off the receiver sections A and B . Then
keep the button SET pressed while switching
on a receiver section . The display will indicate
or , with the number flashing .
2) Press the button SET to activate the squelch
setting mode:
current value (flashing) will appear on the
display .
3) Use the button  or  to set the value
(level 7 = highest threshold value) . Press the
button SET to exit the squelch setting mode .
Note: The setting modes will be automatically exited
after 5 seconds if no button is pressed . Any settings made
will be saved .
(for "Squelch") and the
17