Scope Of Delivery; Accessories; Safety Instructions; General Safety Instructions - EFA Z079 Betriebsanleitung

as well as resistance against static and dynamic
stress during operation, article 1.3.10 of the
Pressure Vessel Directive 97/23/EC applies.
As pressure is not a decisive factor when it comes
to the design of the cutter, the EFA hook cutter is
not subject to the above directive.

1.3 Scope of delivery

Hook cutter
Operating manual

1.4 Accessories

Spring-loaded pulley
Hose kit
Hydraulic unit
Hydraulic fluid
For order numbers of standard equipment and
accessories, please refer to Appendix A "List of
Spare Parts and Wear Parts" (page 13).

2. Safety instructions

2.1 General safety instructions

When operating the hook cutter, always adhere to
the following safety instructions:
Before replacing the cutter blades, or carrying
out installation, maintenance or repair work,
disconnect the machine from the hydraulic
network.
Only personnel who have been properly trained
and instructed in the safe use of the hook
cutter may handle the tool.
All personnel working with the tool must be
instructed by our specialist technicians.
Installation, maintenance and repair work may
only be carried out by suitably trained and
authorised specialists technicians.
Hook cutters by S&W conform to all relevant
safety standards.

2.2 Workplace safety

1. Keep your workplace tidy. Any kind of clutter
lead to an increased risk of injury!
2. Ensure that the workplace environment is
Schmid & Wezel
D75433 Maulbronn,
suitable for the use of the tool and properly
illuminated (min. 500 lux).
3. Prevent unauthorised persons from accessing
your workplace. Concentrate on your work and
use common sense. Do not handle the hook
cutter, if you feel tired and/or find it difficult to
concentrate.
4. Keep the hook cutter in a safe place. While not
in use, store it in a dry place.
5. Work clothing: Do not wear loose clothing or
jewellery, as such items could become
entangled in moving machine parts. Wear
safety footwear. Always wear a hairnet!
6. Avoid an unnatural posture. Make sure that
you stand firmly and do not lose your balance.
7. Handle your tools with care. Use only sharp
and undamaged cutter blades to ensure safe
and efficient working.
8. Use only original EFA blades. Always adhere to
the instructions for the replacement of blades.
See also chapter 4.1.1 "Removing blade" (page
6).
9. Never leave spanners or wrenches attached to
the tool. Before starting the machine, inspect
the cutter to ensure that all spanners and
wrenches have been removed.
10.Use only original EFA accessories. Warranty is
voided, if other accessories are used. If other
tools inserts or accessories are used, there is
also an increased risk of injury to the operator
and other persons.
11.It is prohibited to modify the machine in any
way. S&W rejects any liability for damages
arising from modified equipment.
3. Commissioning and
operational safety
Workplace
The working area for the operator must be at
least 1.5 m². This area must be kept clear and
may not be shared with any other staff, as the
cutter is moved during operation and could injure
other persons.
The working area must be illuminated with min.
500 lux.