Start-Stop Pliers En - Abicor Binzel FES-200 Betriebsanleitung

6 Putting into operation
6.1 Start-stop pliers
The start-stop pliers allows you to switch on automatically the FES-200 when the welding process starts.
3
1 Manometer
Fig. 5 Start-stop pliers
Mounting the start-stop pliers:
1 Connect the connector to the FES-200.
2 Put the start-stop pliers (3) around the cable assembly of the welding fume extraction torch.
3 Turn the rocker switch (2) to the Auto position.
The FES-200 starts automatically when the welding process is started.
NOTICE
• Type France: connect the additional exhaust air hose to the exhaust box.
 Fig. 2 Functional Description on page EN-12
• Switch on the automatic function to increase the service life of the fume extraction system.
• When an increased smoke concentration is detected in the working area:
• Stop the welding process.
• A function check is required before putting into operation.
4 Switch on the device at the rocker switch (2)
• Manual = continuous operation
• 0 = off
• Auto = start-stop pliers are active (device runs only during the welding process, and keeps running for the set time of
approx. 1 minute).
6.2 Installation
Select a location that allows a short and straight extraction hose feed and prevents it from entering the employee's space of
movement.
EN - 16
2 Rocker switch (manual-0-Auto) 3 Start-stop pliers, 4 pole (deviating figure possible)
BAL.0209.0 • 2019-08-06
FES-200
1
2