Gpio Line Input Logic - Telos Alliance xNode Serie Bedienungsanleitung

GPIO Line Input Logic

Name
INPUTS
ON Command
OFF Command
PREVIEW Command
RESET Command
READY Command
OUTPUTS
ON Lamp
OFF Lamp
PREVIEW Lamp
START Pulse
STOP Pulse
POWER & COMMON
Source Common
Logic Common
Logic + 5 Volt supply
Source Supply
NOT CONNECTED
Pin
11
12
13
14
15
1
2
3
4
5
7
8
9
10
6
© 2017 Telos Alliance - Rev 2.0.1
Type
Active Low Input
Active Low Input
Active Low Input
Active Low Input
Active Low Input
Open Collector to Logic Com-
mon Return
Open Collector to Logic Com-
mon Return
Open Collector to Logic Com-
mon Return
Open Collector to Logic Com-
mon Return
Open Collector to Logic Com-
mon Return
Logic Common
Internal 5 Volt return
Logic Supply, Individually
Fused
Common for all 5 inputs
Notes
Turns channel ON
Turns channel OFF & sends
100 msec STOP pulse
Turns preview ON
Turns channel OFF, while not
sending a STOP pulse
Illuminates OFF lamp to indi-
cate source's readiness
Illuminates when channel is
ON
Illuminates when channel is
OFF and READY is active
Illuminates when PREVIEW
is ON
A 100 msec pulse when the
channel status changes from
OFF to ON
A 100 msec pulse when the
channel status changes from
ON to OFF
Connect to ground of source
device or to Pin 8
Can be connected to Pin 7
if source is not providing
common
Can be connected to Pin 10
if source is not providing
voltage; active only when
source has been assigned to
channel.
Connect to power supply of
source device or to Pin 9
GPIO v."ZA" 4/2009