Inhaltsverzeichnis
Werbung
In the Sources section you will provide a name value to help identify the audio source in network advertisements.
If a unique ID was assigned to the node, the sources were automatically given channel numbers. Sources are the
xNode's audio inputs. These inputs are known within the network as sources and go to Destinations.
Destinations of the xNode are the audio outputs. The Name field is used for documenting what is connected to the
audio output port. Channel field is where you select an audio stream from the network to provide audio for the out-
put. If you don't know the channel number, use the browse button immediately to the right to search the network for
the desired source. Selecting the source from the pop-up window will populate the channel value of the Destination
field.
The GPIO section provides a name field for documenting the purpose of the port. The channel field is used to either
enter in another node's IP and port for GPIO routing, or a Livewire channel for Control surface logic. More on this
topic is covered in Chapter 7.
Restoring Defaults
Performing factory reset will clear all configurations and return the xNode to a "blank canvas". To restore default,
execute the following steps.
•
Disconnect all power from the xNode, then press and hold the two front panel buttons.
•
Apply power to the xNode while continuing to press the buttons.
•
xNode will show a countdown timer for factory reset. When the timer reaches 0, release the two buttons.
© 2017 Telos Alliance - Rev 2.0.1
Werbung
Inhaltsverzeichnis
