Inhaltsverzeichnis
Werbung
Chapter Two:
Configuration
There are different options for how the xNode can be configured; iProbe, assigning an ID to the xNode, or manually
configuring the IP address. In the fast setup, we will use the ID method. Following subsections of this chapter will
cover the other methods in detail.
Fast Setup
•
Apply power to the xNode and wait for the boot process to complete showing you a home screen identify-
ing the xNode and version.
•
Press the top button, the screen button, twice to reach the ID page which shows you a Node ID with no
value, Channel numbers 1-8 and no IP address (shown in Figure 2-1)
•
Press the second button, pencil icon, for 10 seconds to enter into edit mode.
•
With the cursor shown, you can use the top button (I
move the cursor to the next position. Press "next" button twice and press the increment button once to give
the ID value of 1 to the xNode. (You'll give a different ID number to each xNode you install.)
•
Pressing the move button one additional time completes edit mode and automatically configures the xNode
with IP address 10.216.0.101 and channel numbers of 101 – 108.
•
That's actually the end of fast setup! With IP and channel numbers configured, you can attach the xNode to
your network and begin connecting sources. But let's continue on for some quick customization.
•
Connect a cross over cable between a computer and the xNode or connect the xNode to the appropriately
configured switch.
•
Set a static IP address to your computer that has a link to the xNode directly or through a network switch.
(an IP address of 10.216.0.100 would be suitable)
•
Open a browser and type in the IP address of the xNode (10.216.0.101) into the URL field.
•
Default Authentication is:
Username: user
Password: (there is no password)
Figure 2-1
) to increment value and the bottom button ( ) to
+
© 2017 Telos Alliance - Rev 2.0.1
Werbung
Inhaltsverzeichnis
