Inhaltsverzeichnis
Werbung
The home page will show system information.
(shown if ID assigned): An xNode can be assigned an ID which is used to assist with IP addressing and
Node ID:
channel numbering.
The code version which is used by the xNode.
Software Version:
The temperature reading of the internal censor. Alarm status will appear if the temperature is above
Temperature:
acceptable limits.
Sync (in audio xNodes):
represents synchronization with the network.
Status of the network ports and which is the active port.
Net1 and 2:
Offline Power and Power Over Ethernet:
The amount of time since the last bootup.
System Uptime:
From the Home page are links to other options. These links are covered in Chapter 3-8.
Using iProbe will allow a user to see all devices on the network. A left click on a device icon will enable the
user to open the configuration user interface (UI). This UI is presented on the screen of iProbe and is the
HTML interface as mentioned here. Authentication is the same through iProbe as with a web browser.
Indication if the device is receiving sync from the network. A solid SYNC indication
Status of power sources.
© 2017 Telos Alliance - Rev 2.0.1
Werbung
Inhaltsverzeichnis
