Christopeit Sport ET 2000 Montage- Und Bedienungsanleitung Seite 19

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts are connected directly to the main
frame preassembled. In addition, there are several other individual parts
that have been attached to separate units. This will makes assembly
easier and quicker for you. Assembly time: 30 - 40 min.
Step 1:
Attach the stabilizer (2+3) at main frame (1).
1. Attach the front foot (2) with the preassembled transport rollers (10)
to the main frame (1). Do this with the two screws M8x75 (5), washers
8//25 (6), spring washers M8 (15) and cap nuts M8 (7).
2. Attach the rear foot (3) to the main frame (1). Do this with the two screws
(5), washers (6), spring washers (15) and cap nuts (7). After assembly
has been completed, you can compensate for minor irregularities in
the floor by turning the adjusting end cap (4). The equipment should
be set up that the equipment does not move of its own accord during
a training session.
Step 2:
Attach the pedals (9R+9L) at pedal crank (8).
1. Attach the pedal straps to the appropriate pedals (9R+9L).
NOTE: The end with many adjustable holes must be set outwards.
2. The pedals (9R+9L) are marked with „R" & „L"
NOTE: Right and Left is specified as viewed seated on the machine
during training.
Connect each pedal (9R+9L) to the matching pedal crank (8R+8L)
(NOTE: The right pedal „R" should be threaded on clockwise. The left
pedal „L" should be threaded on counter-clockwise.)
19