Remedy Of Faults; Maintenance And Cleaning - Oase LUNAQUA 3 Gebrauchsanleitung

- EN -
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
Adjusting the cone of light
N O T E
Do not loosen the union nut. Water may enter the spotlights and destroy the unit.
 H
• The angle of the cone is infinitely adjustable by turning the focusing ring (from 10° - 40°).

Remedy of faults

S
Malfunction
Spotlight does not light up
Illuminating power decreasing
Water inside the spotlight housing
S

Maintenance and cleaning

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
If necessary, clean the unit with clear water using a soft brush.
• Ensure that no moisture can enter the unit.
14
Cause
Power supply interrupted
Bulb defective
Transformer defective
Lamp glass soiled
The brightness of the bulb reduces as the oper-
ating time increases
Seal defective
Remedy
Check power supply
Replace bulb (→ Replacing the coloured disk
or bulb)
Replace transformer
Clean
Replace bulb (→ Replacing the coloured disk
or bulb)
Check sealing rings and replace, if necessary