Remedy Of Faults - Oase ProfiLux LED 350/01 Gebrauchsanleitung

- GB -
ProfiLux LED 1100/01
How to proceed: 4.
0.
E, F
1. Loosen the Allen screws on both sides of the spotlight and tilt the spotlight to allow access to the slot of the installa-
tion bracket.
2. Fasten the installation bracket to the ground/base.
3. Align the spotlight and tighten the Allen screws on both sides.
ProfiLux LED Spot 2200/01, ProfiLux LED Flood 2200/01
How to proceed: 4.
0.
G, H
1. Loosen the Allen screws on both sides of the spotlight and tilt the spotlight to allow access to the slot of the installa-
tion bracket.
2. Fasten the installation bracket to the ground/base.
3. Align the spotlight and tighten the Allen screws on both sides.
Connecting the spotlights
4. How to proceed:
0.
I
1. Remove the protection cap from PowerBox 24 V DC.
− The two 24 V DC sockets are connected in parallel. The second 24 V DC socket can be used for supplying other
units (signal feed-through).
2. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
− Ensure that the rubber seal is clean and fits exactly.
− Replace the rubber seal if damaged.

Remedy of faults

Malfunction
Spotlights do not light up
Individual spotlights are not lit.
Insufficient luminous intensity of the spotlight
Repair
The unit can only be repaired by OASE. Please send the unit to your OASE dealer.
14
Cause
No supply voltage
Switching power pack defective
Supply voltage incorrectly connected (poles
reversed)
Spotlight(s) not connected
LEDs defective
Switching power pack output defective
Operating temperature too high, luminous
intensity automatically reduced.
Spotlight glass soiled
Remedy
Check all cables and connections.
− Refer to instructions for use of switching
power pack.
− Replace switching power pack.
Correctly connect supply voltage.
Check spotlight connection.
Replace spotlight(s).
− Connect spotlight(s) to other output.
− Replace switching power pack.
No measure necessary
Clean spotlight glass.