HELIX D ONE Bedienungsanleitung Seite 18

Example configurations for Master / Slave Mode
Signal from the radio
(RCA/Cinch or highlevel)
Master
Master
Attention: The second voice coil of the
subwoofer must be connected in re-
versed polarity to the amplifier which
is adjusted as "Slave"!
18
Amplifier connection in Master / Slave Mode
Master
Switch setting:
Master
Speaker connection in Master / Slave Mode
Slave
Slave
RCA/Cinch cable
One subwoofer with one voice coil
(single voice coil)
Maximum output power of this configuration:
1 x 4 Ohms: 645 / 1,290 Watts
1 x 2 Ohms: 910 / 1,820 Watts
Note: The negative terminals of both amplifiers have to
be connected by using a speaker wire. The size should
be similar to the speaker wires which are used for the
subwoofer connection.
One subwoofer with dual voice coil
(dual voice coil)
Maximum output power of this configuration:
2 x 4 Ohms: 400 / 800 Watts
2 x 2 Ohms: 680 / 1,360 Watts
2 x 1 Ohm: 1,060 / 2,120 Watts
Note: In this configuration example an 1 Ohm configura-
tion in Master / Slave Mode is possible but not advisable!
Slave
Switch setting:
Slave