HELIX D ONE Bedienungsanleitung Seite 12

Connectors and control units
Line Input
1
RCA inputs for connecting lowlevel line
signals.
Highlevel Input
2
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
lowlevel line outputs.
.
Level Input
3
Control for adjusting the input sensitivity of
the lowlevel Line and Highlevel Inputs.
Phase Shift
4
Control for adjusting the phase from 0° to
180°.
Bass Boost
5
Control for adjusting the bass boost from 0 to
12 dB.
Speaker Output
11
Speaker outputs for connecting subwoofers.
Power & Protect LED
12
This LED indicates the operating mode of the
amplifier.
Fuse
13
Input fuses - 2 x 30 Ampere.
12
1 2 3 4 5
11 12
6 7 8 9
Subsonic
6
Control for adjusting the subsonic filter from
10 to 50 Hz.
Remote
7
Input for connecting the included cable
remote control for volume adjustment.
LPF
8
Control for adjusting the lowpass filter from
50 to 250 Hz.
Master / Slave Mode
9
Switch for operating two D ONE amplifiers in
bridge mode.
Mono RCA/Cinch In-/Output
10
Mono RCA/Cinch signal in- or output for
bridge mode operation in Master / Slave
Mode.
13 14 15
+12 V
14
Connector for the +12 V power cable of the
positive terminal of the battery.
REM
15
Connector for the remote cable.
GND
16
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
10
16