Making Settings - Grohe Euroeco Cosmopolitan E series Handbuch

GB

Making settings

The infrared electronics provide seven preset programmes for selection. Programme 1 is set at the factory.
Programme Temporary
shutoff*
Programme 1
Programme 2
Programme 3
Programme 4
Programme 5
Programme 6 Inactive
Programme 7 Inactive
* Cleaning mode can be activated when temporary shutoff is activated. In cleaning mode, water flow is not started for 3 minutes
despite an object being detected.
** Automatic flushing serves to ensure water hygiene if the fitting is not used for a prolonged period. Flushing is initiated for
a duration of 1, 5 or 10 minutes after 24 hours (usage-independent) or 72 hours after the fitting was last used (usage-
dependent).
Safety note:
Ensure free draining when automatic flushing is activated.
The fitting can be individually programmed using the remote control (see Special accessory, Prod. no.: 36 206).
Selecting a programme
The programme is selected via the infrared sensor system.
1. Activate setting mode:
Disconnect the power supply to the electronics and re-connect after 10 s. Setting mode is active for 3 minutes.
3
On/off
Active Off
Active On
Active On
Active On
Active On
Off
On
Automatic flushing**
Flush interval Flush duration
-
72 h 5 min
24 h 5 min
72 h 10 min
72 h 1 min
-
72 h 5 min
Usage-dependent/
usage-independent
- -
Usage-dependent
Usage-independent
Usage-dependent
Usage-dependent
- -
Usage-dependent
Duration of
thermal
disinfection
3.5 min
3.5 min
11 min
3.5 min
3.5 min
3.5 min
3.5 min