Grohe Euroeco Cosmopolitan E series Handbuch Seite 5

2. Hold finger against the lower area of the sensor system.
The indicator lamp in the sensor system flashes quickly.
3. Remove finger from the sensor system once the indictor lamp goes out. Programme selection mode is activated.
4. Replace finger against the lower area of the sensor system.
The programmes are indicated by groups of flashing signals via the indicator lamp. The groups are separated by a pause.
5. Programmes and indication:
Indication starts with the programme that is currently set. The number of flashing signals corresponds to the individual
programmes.
1 = Programme 1
Pause
2 = Programme 2
Pause
- etc.
7 = Programme 7
Pause
After the group with 7 flashing signals, the routine starts from the beginning.
1 = Programme 1
...
6. Selecting a programme:
The programme is selected by removing the finger from the sensor system during the pause after the required programme.
The corresponding flashing signals are indicated again after the finger is removed.
7. A new programme can be selected within the next 5 s if required. Programme selection mode is automatically terminated if
the finger is removed from the sensor system before 5 s have elapsed.
Starting cleaning mode
Cleaning mode is activated by holding the finger against the lower area of the sensor system (indicator lamp lights up
continuously, then flashes). Remove the finger when the flashing signals start.
Terminating cleaning mode
Cleaning mode can be prematurely terminated by once more holding the finger against the lower area of the sensor system (the
indicator lamp changes from flashing signals to lighting up continuously). The finger can be removed once the indicator lamp
goes out or cleaning mode ends automatically after 3 minutes.
Signalling the remaining battery capacity and performing thermal disinfection
Hot water must be provided by the customer.
Thermal disinfection is started and the remaining battery capacity is signalled by holding the finger against the lower area of the
sensor system (indicator lamp lights up continuously, then flashes slowly, the flashes quickly). Remove the finger when the
quick flashing signals start. The remaining battery capacity is signalled as follows by the number of flashing signals:
4 = Remaining capacity > 60%
3 = Remaining capacity > 40%
2 = Remaining capacity > 20%
1 = Remaining capacity < 20%
Thermal disinfection starts once the remaining capacity has been signalled.
The detection zone of the sensor system must be kept clear while the remaining battery capacity is being signalled.
If an object is detected during thermal disinfection (hot water flow), the water stops flowing immediately and the fitting is closed
(indicator lamp starts to flash).
Closure of the fitting ends automatically after 3 minutes or can be prematurely terminated (see Terminating cleaning mode).
4