Klarstein Creamberry Handbuch Seite 18

EN
18
6
Each time the Reset button is pressed, the
running time is added one minute with a
"beep" in sequence:
8
Press the Power button after the running
time is set.The machine is turned on , the
remaining time "XX:XX" is indicated on
LCD and counts down at once.
10
1Use the chute and pour the ice cream
or sorbet mix into the inner bowl. When
pouring mixture into the bowl, always
stop at least 5 cm (2 inch) from the top,
as the mixture will increase in volume
during freezing.
Important Notes on Use
• Do not stop and start the machine during the freezing process, as the mixture may
freeze in contact with the bowl and prevent movement of the paddle.
• To avoid overheating the motor, the direction of rotation will change if the mixture
becomes too thick. If the direction of rotation continues to change, stop the machine
when the mixture is ready.
• In the unlikely event of the motor overheating, a safety cut out will operate causing
the motor to stop. If this happens, unplug the machine and allow the power unit to
cool.
• For the best result of ice cream, the paddle will contact with the inside of the inner
bowl when the paddle moves.
• When the setting time is over, the machine is stopped automatically, unplug the
machine and remove the power unit/lid. The ice cream is ready to serve.
7
You can choose the running time from
20 minutes to 40 minutes. Each time the
Power button is pressed, the machine is
changed with a "beep" in sequence.
9
Before adding the mixture you can stop
the machine and reset the running time
again that you want.
11
1Allow the mixture to churn until frozen
or the desired consistency is reached. This
can take up to 15 to 30 minutes, but most
recipes will be ready in less time.