Standard Menu - DERMAVIT Diamond Shield IE Professional Bedienungsanleitung

Standard Menu

Executing an entire sequence
Running a single program of a sequence
Under the menu item Standard you will find the pre-
installed frequency applications, with which the Diamond
Shield IE Professional Zapper is supplied by default.
Most of these applications consist of a sequence of seve-
ral sub-programs. The first level of the menu shows the
available sequences. When a sequence is selected and
then the OK button is pressed, the frequency programs of
the selected sequence are displayed and can be executed
singularly.
Select the desired sequence with the + and - button.
To run the entire sequence press the START button.
First the device will test the electrical contact (see chapter
Contact control, page 53). Then all the sub-programs of
the selected sequence are successively executed.
Select the desired sequence with the + and - button.
Press the OK-button to enter the submenu, where the sin-
gle frequency programs of this sequence are displayed.
Then select the desired single program and run it by pres-
sing the START-button. Previously the device checks the
electrical contact (see Contact control, page 53).
Diamond Shield IE Professional
Instruction Manual
page 52