Setting Up The Device Control - NARDA SignalShark 3320 Schnelleinstieg

6.4

Setting up the device control

The SignalShark 3320 can be connected in the following ways:
Connecting the SignalShark 3320 to a network
This is the standard connection type. The default setting of the
SignalShark 3320 is DHCP = On. The SignalShark 3320 can then be oper-
ated via remote commands or remote desktop.
1. Connect the SignalShark 3320 to a network using a standard Ethernet
cable (patch cable).
2. Configure your network. For more information, refer to Setting up the
network configuration on page 32.
Connecting a monitor and accessories to the
SignalShark 3320
This type of connection allows you to operate the SignalShark 3320 without
a network. In this way you can, for example, assign an IP address manually
if no DHCP server is available.
1. Connect a monitor to the display port (see Figure 1, caption 6).
2. Connect a keyboard and a mouse to the USB ports
(see Figure 1: caption 7, and Figure 2: caption 5 ).
Narda SignalShark 3320 Remote Unit 31