Dismounting The Appliance; Installation With Feet; Power Supply; Troubleshooting - STIEBEL ELTRON CNS 75 F Bedienung Und Installation

1 Locking bolt
2 Wall mounting bracket
1
1 Appliance
2 Safety cap
3 Locking bolt

9.1.3 Dismounting the appliance

Remove the safety cap from the locking bolt.
»
1
1 Appliance
2 Safety cap
3 Locking bolt
Undo the locking bolt on the wall mounting bracket.
»
Lift the appliance up slightly and pull it forwards and away from
»
the wall mounting bracket.
9.2
Unhook the wall mounting bracket.
»
1
Only remove both external left and right screws at the bottom
»
2
of the appliance.
Fit the feet to the bottom of the appliance in such a way that
»
they are inserted into the recess at the back of the appliance.
2
3
9.3
Ensure the on-site supply cable has an adequate cross-section.
»
Ensure that a socket is installed at a distance of at least 10 cm
»
2
from the side of the appliance.
3

10. Troubleshooting

The power cable must only be replaced by a contractor using our
original spare parts.

11. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety information. Hand the operating and
installation instructions to the user.

Installation with feet

Secure the feet with the One-way Screws supplied.

Power supply

DANGER Electrocution!
Carry out all electrical connection and installation
work in accordance with relevant regulations.
DANGER Electrocution!
The appliance must be able to be separated from the
mains power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
DANGER Electrocution!
Do not install the appliance with a fixed power cable.
Observe the type plate. The specified voltage must
match the mains voltage.