Using The Remote Control - DeLonghi DCH2590ER Bedienungsanleitung

Timer function
The timer function can be activated in any operating mode. The timer can be used to program-
me the time the appliance remains in operation from 1 to 8 hours.
Each time button (C) is pressed, the operating time increases by one hour.
Once set, the operating time decreases each hour and the remaining time is displayed. At the
end of the set time the appliance goes off.
If you do not want to use the appliance with the timer function, press button (C) again to go
back to manual mode.
Note: The display shows room temperature in either °C or °F. To select the required unit of
measurement, press the + and - buttons together for a few seconds, then release.
MOTORIZED ROTATING BASE
To distribute the air flow over a larger area, with the appliance on press A button once more.
The appliance swings from right to left.
To stop the appliance in the desired position, simply press the A button again.
To turn the appliance off, press button A for a few seconds and place the switch on the back in
the 0 position.

USING THE REMOTE CONTROL

The remote control should be handled with extreme care and respect.
1. Press button (G) to turn the appliance on.
2. To use the SWING (button H), SET TIME (button C), MODE (button B) and temperature
regulation (button F) functions, see the OPERATION AND USE section.
3. To replace the batteries, remove the cover on the back of the remote control unit.
The remote control uses two AAA type alkaline batteries (included, but packaged separately).
4. Do not mix used and new batteries with different values.
WARNINGS
- Do not use this heater near showers, bathtubs, sinks, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry laundry. Never obstruct the intake and outlet grilles (danger of
overheating).
- Do not allow children or unfit persons to use the appliance without adequate supervision.
- Do not allow children to play with the appliance.
- The heater must be positioned at least 50 cm from furniture or other objects.
- Do not use the appliance near walls, furniture, curtains, etc.
- The use of extension leads is not recommended. However if they cannot be avoided, follow
the instructions accompanying the extension lead and never exceed the power limit marked
on the extension.
- If the power cable is damaged, it must be replaced by the manufacturer, an authorised ser-
vice centre or a qualified electrician in order to eliminate all risk.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not use the appliance in rooms with a floor area of less than 4 m
The heater is fitted with a safety device which switches it off in the event of accidental
overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at
all). To reset, unplug the appliance from the mains socket for a few minutes, remove the
cause of overheating then plug in again.
WARNING: In order to avoid overheating, never under any circumstances cover the
appliances during operation,as this would lead to dangerous overheating.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this applian-
ce must not be supplied through an external switching device, such as a timer, or connected to a cir-
cuit that is regularly switched on and off by the utility.
8
.
2