Omnitronic RS-1622 Bedienungsanleitung Seite 15

38 Selector switch L-R/G 1-2 PFL
When engaged, the LED level meter indicates the
group signal of outputs G1 and G2 or the PFL bus
signal.
39 Selector switch G 1-2/PFL
• Switch engaged: The LED level meter indicates the
group signal of outputs G1 and G2
• Switch disengaged: The LED level meter indicates
the PFL bus signal.
29 Level control TAPE IN
Level control for the input TAPE IN.
30 LED level indicators
10-digit LED level indicators for the master signal within
the range of -20 dB to +10 dB. Alternatively, the group
signal at outputs G1 and G2 or the PFL bus signal is
shown when the button L-R/G 1-2 PFL is engaged.
31 Controls AUX SEND 1 and 2
Adjust the signal level for the effect ways SEND 1 and 2.
32 +48V indications
Lights up with activated phantom power.
33 Power indicator
Lights up when the mixer is powered on.
34 Controls RETURN 1 and 2
Adjust the intensity of the effect added. The further the
respective control is advanced, the more intense the effect.
35 Selector switch +48V
When engaged, a 48 V phantom power is switched on for
all microphone inputs MIC.
Caution! If the phantom power is switched on, no
unbalanced microphones must be connected. Otherwise,
these microphones may be damaged.
36 Control HEADPHONES/CTRL ROOM LEVEL
Level control for the PFL output HEADPHONES and the
monitor CTRL R OUT.
37 Selector switch L-R to G 1-2
When engaged, the respective Aux signal is sent to the
group signal.
40 Selector switch G 1-2 to L-R
When engaged, the group signal is sent to the master
signal.
41 Fader for the master signal
The master siganl is sent to the outputs MAIN OUT,
TAPE OUT and CTRL R OUT.
42 Fader G 1-2
Level control for the group signal.
15/18 00065097.DOC, Version 1.2