Omnitronic RS-1622 Bedienungsanleitung Seite 14

14 Selector switch L-R
When engaged, the channel signal is sent to the main
mix fader. To mute a channel, disengag the selector
switch. Note: AUX signals cannot be muted with this
switch.
17 Connectors INSERT 1 to 4
Insert jacks 1 to 4 for inserting an effect unit (e.g.
dynamic processors, equalizers or other sound effectors)
into the master signal.
The stereo master signal is taken off pre-master via the
insert jacks, routed via the effect unit and fed back into
the channel at the same place of the signal way.
18 Inputs AUX RETURN 1 and 2
Stereo inputs (bal. 6.3 mm jacks) for connecting units
with line level outputs (e.g. effctors). When connecting a
mono device, only use the left jack L/MONO.
19 Outputs AUX SEND 1 and 2
Outputs (bal. 6.3 mm jacks) for connecting units with line
level inputs (e.g. effctors).
20 Outputs GROUP OUT G 1 und G 2
Outputs (bal. 6.3 mm jacks) with the group signal for
connecting a headphones amplfier e.g. for the back-
ground singers.
21 Output MAIN OUT L/R
Main output (bal. 6.3 mm jacks) for the master signal for
connecting an amplifier or a further mixer.
15 Selector switch G 1-2
When engaged, the channel signal is sent to the group
signal. Useful e.g. to sum up different input channels into
one group such as drums, winds or background singers.
16 Channel fader
Adjusts the signal level of the respective input channel in
or/and G1-2).
the mix (L-R
22 Power switch
Turns power to the unit on and off.
23 Power input
Plug in the supplied power unit here.
24 Headphones output
6.3 mm jack for connecting stereo headphones (min.
impedance 8 ).
25 Input TAPE IN
Stereo RCA connector for connecting the output of a
recorder.
26 Output TAPE OUT
Stereo RCA connector for the master signal (post-fader)
for connecting a recorder.
27 Output CTRL R OUT L/R
Output (bal. 6.3 mm jacks) for connecting an amplifier of
a monitor system.
28 Output MAIN OUT L/R
Main output (3-pin XLR) for the master signal
connecting an amplifier or a further mixer.
14/18 00065097.DOC, Version 1.2
for