Maintenance And Cleaning; Overload Clutch - Bosch PBH 300 E Bedienungsanleitung

EURO • Printed in Germany • BA 1 619 929 477 • PBH 300 E • GB • OSW 11/99
PBH 300 E - Buch Seite 15 Montag, 8. November 1999 4:36 16
Chiselling Position (Vario-Lock)
The chisel can be locked in 36 positions. In this
manner, the optimum working position can be set
for each application.
Insert the chisel in the tool holder.
Press the release button 5 and turn the mode se-
lector switch 6 at the same time to the "Chisel
(Vario-lock)" position.
Turn the tool holder to the desired chiselling posi-
tion.
Allow the mode selector switch 6 to latch in the
"Chiselling" position. The tool holder is locked in
this position.
The mode selector switch 6 must always be
locked in the "Chiselling" position when chis-
elling.

Overload Clutch

If the drill becomes caught or jammed, the
drive to the drill spindle is interrupted.
Because of the forces that occur as a result,
always hold the machine securely with both
hands and take a firm stance.
Sharpening Chisels
Since good results can be achieved only with
sharp chisels, sharpen the chiselling tools regu-
larly. This prolongs the service life of the tools and
ensures good working performance.
Sharpen chiselling tools using grinding wheels
(e. g., special fused alumina) with a steady supply
of water. Recommended values for this purpose
are contained in figure E. Take care that no an-
nealing coloration appears on the cutting edges,
otherwise the hardness of the chiselling tools will
be impaired.

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
Keep the tool holder clean at all times.
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorised customer
services centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the plug is cut off of
the cable of this machine, it must be disposed of
safely and not left unattended.
Guarantee
We guarantee Bosch appliances in accordance
with statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the Bosch Serv-
ice Centre for electric power tools.
To be fitted
by qualified
professional only
15