Using The Device; Switching On The Device; Status Indications - Dometic DSP 1212C Montage- Und Bedienungsanleitung

Using the device

➤ Press the selector button to save the selected value.
✓ The DSP-EM shuts off.
Reset the device to factory settings
➤ Switch on the system.
✓ The number "1" appears on the DSP-EM's display.
➤ Turn the selector button until the number 35 is displayed.
✓ The display shows the service code "S-35".
➤ Press the selector button to reset the device.
11 Using the device
11.1

Switching on the device

➤ Set the main switch (fig. 1 3, page 1) of the device to the "ON" position.
Set the On/Off switch to "OFF" to switch off.
➤ The device performs a self-test.
✓ After the self-test is completed successfully, the LED lights up blue (fig. 1 2,
page 1).
11.2

Status indications

The blue LED (fig. 1 2, page 1) shows the operating condition of the device.
Display
Constantly lit
Long flash, short interruption
Quick flash
Off
20
Input voltage
Normal mode
Device overheated/Overload
Overvoltage/Undervoltage
Other fault
SinePower
EN