Troubleshooting - Klarstein 10030350 Handbuch

Problem
Electric element will
not heat up.
Grill is not getting hot
enough.
Grill is getting too hot.
35

Troubleshooting

Cause
The plug is not fully seated in the
outlet..
A circuit breaker has tripped. A
fuse is blown.
Electric element only heats up
(becomes red) during the first
4 minutes after power switch is
turned on.
Adjust temperature control on
temperature controller..
You check the food to often.
Verify that there are pellets in
pellet hopper.
Fire goes out on "LOW" setting.
Adjust temperature control.
Solutions
Reseat plug in a 3­wire grounded
GFCI outlet wired for 120 volts and
protected at 7 or 10 amps.
Reset breakers or replace fuse.
Turn Power switch "Off" then "ON"
again.
Turn up heat on control dial.
Opening the door allows heat to
escape and slows the cooking process;
open door only when necessary.
Add pellets and allow sufficient time
for the pellets to travel from the pellet
hopper to the firepot (can take up to
7 minutes).
4. Excess ash. IMPORTANT: Remove
all unburned pellets and ash from
inside and around the firepot. A shop­
vac is ideal for the task CAUTION!
ASSURE THAT THE GRILL IS COLD
TO AVOID A FIRE FROM HOT ASH.
Turn down heat on temperature
control dial..