Troubleshooting - Klarstein VALDOSTA 3.1 Bedienungsanleitung

• Periodically check the burner to see that it is free from insects and spiders which
may clog the gas system, deflecting gas flow. Ensure to clean venturi pipes on
burner very carefully, make sure that there are no obstructions. We recommend that
you use a pipe cleaner to clean the venturi pipe area.
• Do not obstruct the fire opening of the container compartment. If the fire opening is
obstructed, please use a round stick with 1.6 mm diameter to dredge.
• Take care not to enlarge burner ports or orifice/nozzle openings when cleaning the
burner or valves.
• Any modifications of this appliance may be dangerous and are not permitted.

TROUBLESHOOTING

Problem
Gas leaking from
cracked/cut/burned
hose.
Gas leaking from gas
cylinder.
Gas leaking from gas
cylinder valve.
Gas leaking between
gas cylinder and
regulator connection.
Fire is coming through
control panel.
Possible Cause
Damaged hose
Mechanical failure due
to resting or mishandling.
Failure of gas cylinder
valve from mishandling
or mechanical failure.
Improper installation,
connection not tight,
failure of rubber seal.
Fire in burner tube
section of burner due to
partial blockage.
Prevention / Solution
Turn off gas at the gas
cylinder, if hose is cut or
cracked, replace hose.
Reconnect the gas cylinder to
the grill and perform a leak
test.
Close the gas cylinder valve.
Turn off gas cylinder valve.
Return gas cylinder to gas
supplier.
Turn off gas cylinder valve,
remove regulator from
cylinder and visually inspect
rubber seal for damage.
Follow the instructions for the
leak test and for connecting
the gas pressure regulator to
gas cylinder (in the "Safety
instructions" and "Installation"
sections).
Immediately set all control
knobs to "OFF" and close the
gas cylinder valve. After the
flames have extinguished and
the grill has cooled down,
remove the burner and inspect
it for spider nests or rust (see
"Cleaning" section).
EN
53