Electrolux IK3318CAR Benutzerinformation Seite 13

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastCool", or
after changing the temper‐
ature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
dEMo appears on the dis‐
play.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastCool function"
is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the
appliance is too low and
the ambient temperature
is too high.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The "FastCool function"
is switched on.
The appliance is in dem‐
onstration mode.
ENGLISH
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastCool function".
Refer to "Closing the door".
Set a higher temperature.
Refer to "Operation".
Set a higher temperature.
Refer to "Operation"
The compressor starts after
a period of time.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastCool func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastCool function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
13