Eldom Ride DA34 Gebrauchsanleitung Seite 10

Set the temperature with the thermostat knob (6). The light (1) will go on.
Ironing may be started when the light (1) goes off, which means that the iron reached the required temperature.
The thermostat will maintain the selected temperature, which will be signalled with the light (1) going on and off.
IRONING WITH STEAM
Ironing with steam and the steam shot function is only possible when high temperature is set. The range of
temperature appropriate for use of steam is marked on the knob of the thermostat (6)
" " The steam function will not work correctly with different settings. Instead of producing steam, the iron
will spill water, which is a normal symptom and is not subject to guarantee repairs.
The button (3) may be used to release additional volume of steam. The additional steam shot facilitates ironing
of exceptionally resistant creases.
NOTE.
Steam is hot. Danger of scalding or burns.
The sole of the iron is heating up very quickly and needs more time to cool down. It must not be touched.
FILLING IN WITH WATER
Before filling up or replenishing water in the tank (5), disconnect the device from the mains. The iron may be
filled up with clean tap water at room temperature or with distilled water. Never use mineral water, water with
high calcium content or water for batteries. Use the enclosed container (with the shape matching the inlet
opening) to fill up the iron tank.
Never pour water to the iron directly from the tap!
When pouring in water to the iron, make sure that the water level is below the "MAX" mark on the tank (5).
TIPS
- use tap or distilled water for the iron,
- reducing temperature with the thermostat knob will not make it go down immediately, you need to wait for
the indication light to go on,
- do not use steam when the temperature is set to low,
- the iron should be stored disconnected from the mains, cooled down and without water,
- make sure to empty the tank (5) for travel. After emptying the tank (5), putting the iron aside is recommended
for a longer time on the surface absorbing humidity so as to remove all residues of water.
CLEANING AND MAINTENANCE
Before cleaning, plug out the iron and wait for it to cool down completely.
The iron must not be immersed in water.
The iron must not be cleaned with rough, abrasive cloth or sponge, as it may destroy the device.
Wipe the body of the iron and the sole with a damp cloth, and dry it up with a clean cloth.
PROTECTION OF THE ENVIRONMENT
- The device is made of materials that may be reprocessed or recycled,
- they are to be delivered to the point of collection and recycling of electrical and electronic devices.
GUARANTEE
- The device is intended for private household use,
- it may not be used for professional applications,
- the guarantee shall become void if the unit is improperly operated.
•
10 EN