Safety Instructions; Electrical Connection; Water Connection - Electrolux GA55LSIWE Benutzerinformation

4 www.electrolux.com
Put the cutlery in the cutlery basket with the sharp ends
•
pointing down or put them in the cutlery drawer in a
horizontal position with the sharp edges down.
Do not leave the appliance with the open door
•
unattended to avoid stepping accidentally onto it.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the
socket.
Do not use high pressure water sprays and/or steam to
•
clean the appliance.
If the appliance has ventilation openings in the base,
•
they must not be covered e.g. by a carpet.
The appliance is to be connected to the water mains
•
using the new supplied hose-sets. Old hose sets must
not be reused.

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Do not install or use the appliance
where the temperature is less than 0
°C.
• Follow the installation instruction
supplied with the appliance.
• Make sure that the appliance is
installed below and adjacent to safe
structures.

2.2 Electrical connection

WARNING!
Risk of fire and electrical
shock.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by
our Authorised Service Centre.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• This appliance complies with the E.E.C.
Directives.
• Only for UK and Ireland. The appliance
has a 13 amp mains plug. If it is
necessary to change the fuse in the
mains plug, use fuse: 13 amp ASTA
(BS 1362).

2.3 Water connection

• Do not cause damage to the water
hoses.
• Before connection to new pipes, pipes
not used for a long time, where repair
work has been carried out or new
devices fitted (water meters, etc.), let
the water flow until it is clean and clear.