Emergency Stop; Start-Up Subsequent To An Emergency Stop; Standard Maintenance - GENTILIN C 330/04 Bedienungs-Anleitungen

Rev. 00 - 06/2014 - Instruction manual Compressor C 330/04 - C330/10 - C330/10+10 - C330/100
Appliance emergency stop can be carried out by turning the "ON-OFF"
switch (A) to the "OFF (0)" position.
In order to avoid any possible danger, authorised operators must carry
out the following operations.
1) IMMEDIATELY BRING ThE "ON-OFF" SWITCh TO ThE "OFF (0)"
POSITION (A).
2) IMMEDIATELY NOTIFY ThE "SAFETY MANAGER" (WhERE ThE
APPLIANCE IS USED IN A BUSINESS CONTExT) OF ThE EMER-
GENCY.

START-UP SUBSEQUENT TO AN EMERGENCY STOP

After having resolved the issues which offset the emergency, and checked that no damage and/or anomalies have been
caused to the appliance, with the consent of the safety manager (where the appliance is used in a business context) start
the appliance as described in Paragraph "APPLIANCE ACTIVATION".
All activities carried out to ensure use and operation of the appliance, via various intervention types (regulation, valve
checks, cleaning of air filters, etc.) executed by the authorised maintenance person according to pre-established time
intervals.
aUtHoRiSED oPERatoRS MUSt onlY CaRRY oUt oPERationS FoR WHiCH tHEY aRE QUaliFiED anD
WitH tHE ConSEnt oF tHE SaFEtY ManaGER (WHERE tHE aPPlianCE iS USED in a BUSinESS ContEXt).
it iS FoRBiDDEn FoR aUtHoRiSED oPERatoRS to lEaVE tHE aPPlianCE UnSUPERViSED DURinG oPERation
anD MaintEnanCE intERVEntionS.
FREQUENCY
ONCE A DAY
Safety devices.
Electrical cable and plug.
Tank.
EVERY WEEk
Wheels.
N. 2 air filters.
24

EMERGENCY STOP

STANDARD MAINTENANCE

STANDARD MAINTENANCE TABLE
INTERVENTION AREA INTERVENTION TYPE
Ensure they are intact, correctly installed and functioning.
Visual check of usage status.
Upon termination of each work cycle, rest the appliance on
the ground and drain the tank condensate pump opening the
condensate pump (B).
Wheel pressure check. Subsequently pump up with compressed
air up to a maximum of 2.5 bar.
Unscrew the screws (1).
Remove the cover (2).
Extract the filter (3) and clean it using compressed air.
Correctly replace the cover.
notE: REPlaCE in tHE inStanCE WHERE it iS WoRn.
A