Assembling The Machine - Husqvarna T300 Compact pro Montageanleitung

EN
DANGER
• An incorrect assembly of this micro-cultivator can
lead to serious injury. Make sure that you carefully
follow all the instructions.
Your micro-cultivator is delivered partially assembled. You
only have to assemble the handlebars, the jackleg, the
throttle lever and the Start/Stop switch. This should only
take you a few minutes, if you follow the instructions.
Firstly, remove all the articles from the box.
The list below indicates the parts that are delivered with
your micro-cultivator. Make sure that they are all included.
To assemble your micro-cultivator, you will need a 13 mm
socket wrench and a screwdriver for recessed-head
screws.
We suggest that you pre-assemble all the nuts and bolts
by hand.
Rep. Name
A Engine block and blades
B Low handlebars
C High handlebars
D Intermediary handlebars
E Jackleg
F Packet of nuts and bolts
G Stop/Start switch
with screws
H Throttle lever
I Instruction manual
J Engine oil container
Tools required
(not provided)
• 13 mm socket wrench
• Screwdriver for recessed-head screws.
Rep. Name
1 Notched base screw H M8x20Z
2 Butterfly nut
3 Recessed-head screw M5
4 Beta pin
5 Jackleg pin

ASSEMBLING THE MACHINE

The Nuts and bolts packet (F) contains:
D
Qty
1
1
H
1
2
1
1
I
1
1
1
1
Rep.
Qty
2
6
7
4
1
8
1
9
1
10
G
C
F E
J
13 mm
Name
Screw H M8x40 Z hexagon head 4
Cable support and screw
1 pair of spare cotter pins
for blade attachments
Washer M3.5x10x1.5
Washer M5x11x1
A
B
Qty
4
1
1
2