Troubleshooting; Installation; Installation Accessories - Trotec Pac 2000 S Bedienungsanleitung

Troubleshooting

Fault Cause
The unit does The unit does not have a power
not power on supply:
1 . The unit is not plugged in .
2 . The plug or the socket is damaged .
3 . The fuse has melted .
The unit swit- 1 . The auto power off mode has been
ches itself off
2 . The temperature you selected has
The unit does 1 . The room temperature is lower
not cool in
cooling mode
2 . The unit has switched to frost pro-
LED indicates The sensor for the room tempera-
fault message E2 ture is defect or damaged .
LED indicates The sensor for the evaporator oil pipe
fault message E3 is defect or damaged .
LED indicates The water tank is full .
fault message E4
LED indicates The sensor for the condensator oil
fault message E5 pipe is defect or damaged .

05. Installation

Installation Accessories

1 . Air discharge hose
2 . Connecting piece, air discharge hose
3 . Adapter for air outlet
4 . Remote control
5 . Cap for air outlet adapter
B - 8
activated .
been reached .
than the temperature you have
selected .
tection mode .
3
operating manual – pac 2000 s moBile air conditioning unit
Solution
1 . Plug in the unit .
2 . Have the mains cable or socket replaced by
an electrician .
3 . Have a specialist change the fuse if necessary .
(Specification: 3 .15A/230VAC)
1 . Switch the unit back on again .
2 . Wait until the unit automatically switches it-
self back on again .
1 . The unit will start to cool again when the tem-
perature that has been selected is lower than
the room temperature .
2 . The unit will start to cool again when the frost
protection mode is completed .
The sensor must be replaced with a new sensor .
The sensor must be replaced with a new sensor .
Drain off the water .
The sensor must be replaced with a new sensor .
1
4
2
5
en