Trotec PAC 2000 S Bedienungsanleitung Seite 17

Possible Fault
The unit is not
running .
The unit runs for a
short time only .
The unit is running
but not cooling .
en
Possible Solution
The overload protection has
been activated or the fuse
has melted .
Wait 3 minutes to see if
the overload protection has
been activated .
The batteries in the remote
control are exhausted and
need to be replaced .
The plug of the unit has not
been plugged in properly
The temperature you have
selected is too close to
current room temperature .
Select a higher or lower
temperature if necessary .
The air outlet is blocked .
Remove the obstruction .
A door or window is open .
Another appliance, e . g . a
strong lamp or a heater is
producing heat at the same
time .
The air filter is extremely
dirty and needs to be
cleaned .
The air intake or outlet
is blocked . Remove the
obstruction .
The temperature you have
selected is too high .
operating manual – pac 2000 s moBile air conditioning unit
Water runs out of
the unit while it is
being moved from
one location to
another .
The unit is not
running and the
water container full
indicator (E4) is on .
Drain off the condensation
water first .
Place the unit on a flat
surface to prevent water
from running out and
causing damage to carpets
and flooring .
Remove the rubber stop-
pers from the back of the
unit and allow the water to
drain off .
Please contact a qualified
technician if this problem
occurs repeatedly .
B - 7