Specifications; Electrical Rating Chart; Plug Configurations; Dimensions - Hatco THERMO-FINISHER TF-1900-Serie Installations- Und Bedienungsanleitung

Model
TF-1919
TF-4619
The electrical information in the shaded areas pertains to Export models only.

PLUG CONFIGURATIONS

Units are supplied from the factory with an electrical cord and plug
on the back of the unit. See 2 .
DIMENSIONS - SEE 3 .
EXTERIOR DIMENSIONS
Model (A) Width
TF-1919 51 cm
(20-3/16")
TF-4619 51 cm
(20-3/16")
*
Allow an additional 5 cm (2") minimum for power cord.

UNPACKING

1. Remove unit from box.
2. To prevent delay in obtaining warranty coverage, fill out
and mail in warranty card.
3. Remove tape and protective packaging from all surfaces
of unit.
4. Place wire plate rack on top of rack supports, making sure plate
rack is not in direct contact with glass base. See 4 .

LOCATION

WARNING
For safe and proper operation, the unit must be located
a reasonable distance from combustible walls and materials.
If safe distances are not maintained, discoloration
or combustion could occur. Do not locate unit under shelving
or closer than 31 cm (12") from the ceiling.

ELECTRICAL RATING CHART

Voltage Watts
208 4800
220 4201
240 5000
240 5000
380 (CE) 4513
208 7200
240 7300
240 7300
380 (CE) 6588
(B) Depth* (C) Height
70 cm 43 cm
(27-7/16"*) (17")
70 cm 43 cm
(27-7/16"*) (17")
Amps Phase Plug Configuration
23.1 1
19.1 1
20.8 1
20.8 1
11.9 1
20.1 3
17.6 3
17.6 3
10.0 3
Plug unit into an electrical outlet of the correct voltage, size
and plug configuration. If the plug and receptacle do not match,
contact a qualified electrician to determine the proper voltage
and size and install the proper electrical outlet.
INTERIOR CAVITY DIMENSIONS
Model
TF-1919
TF-4619
Allow a minimum of 3 cm (1") clearance along the sides. Allow
a clearance of 66 cm (26") along the front discharge to ensure
proper operation and safety.
Locate the unit at the proper counter height, in an area that
is convenient for use. The location should be level to prevent
the unit or its contents from accidentally falling, and strong
enough to support the weight of the unit.
Do not place anything on top of the unit; doing so could damage
the unit or subject personnel to possible injury.
6

SPECIFICATIONS

Shipping Weight
NEMA 6-30P 40 kg (88 lbs.)
NONE 40 kg (88 lbs.)
NEMA 6-30P 40 kg (88 lbs.)
NONE 40 kg (88 lbs.)
NONE 40 kg (88 lbs.)
NEMA L15-30P 41 kg (90 lbs.)
NEMA L15-30P 41 kg (90 lbs.)
NONE 41 kg (90 lbs.)
NONE 41 kg (90 lbs.)
WARNING
(D) Width (E) Depth
34 cm 57 cm
(13-5/16") (22-1/4")
34 cm 57 cm
(13-5/16") (22-1/4")

INSTALLATION

WARNING
CAUTION
CAUTION
Form No. TF1946CEM-0802
(F) Height
18 cm
(7-1/8")
18 cm
(7-1/8")