Opening The Lid; At The End Of The Programme - Zanussi ZWT 3206 Benutzerinformation

Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.

OPENING THE LID

While a programme (or the
appliance lid is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the lid.
To open the lid during the first minutes of the
cycle (or when the
1. Touch the button
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
The programme (or the

AT THE END OF THE PROGRAMME

• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display comes on.
• The indicator of the button
• The lid lock indicator
unlocking) and then goes off.
• You can open the lid.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the lid ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
the water.
) operates, the
is on.
operates) :
to pause the appliance.
) continues.
goes off.
blinks (when the lid is
for some seconds to
flashes to remind you to drain
• The lid lock indicator
button
• You must drain the water to open the lid.
Draining the water:
1. To drain the water.
• Touch the button
drains the water and spins with the
maximum spin speed for selected washing
programme.
• Alternatively, touch the button
the spin speed and then touch the button
spins. If you set
drains.
2. When the programme is completed and after a
couple of minutes the lid lock indicator
goes off, you can open the lid.
3. Press the button
deactivate the appliance.
again.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
AUTO-OFF OPTION
The AUTO-OFF stand-by option automatically
deactivates the appliance to decrease the energy
consumption. All the indicators and the display go
off when :
• You do not use the appliance for 5 minutes
before you touch
Press the button
again.
• After 5 minutes from the end of the washing
programme.
Press the button
again.
The display shows the end of the last set
programme.
Touch the button
cycle.
is on. The indicator of
flashes. The lid stays locked.
. The appliance
. The appliance drains the water and
, the appliance only
for some seconds to
.
to activate the appliance
to activate the appliance
if you want to set a new
to change
15