Installation - Cookmax Mvb330 Handbuch

Operators are required to report to their managers any deficiency and / or potentially hazardous situation that
may occur.
The user has the duty to inform the construction company where discovers a covered defect and / or failure
of safety protection systems, as well as any situation of alleged danger becomes aware.

INSTALLATION

After removing the packaging, check the machine. In particular, check that the machine is present whole and
without visible damage that may have been caused by transportation. If in doubt do not use it and contact
the Home Seller.
Place the machine on a plane perfectly level, smooth, dry and suitable for supporting its weight, low humidity
and away from heat sources.
Please observe these essential rules:
- the mains voltage and that on the technical plate must be the same;
- connection must be to an equipotential system.
The electrical connections must be carried out by trained personnel in accordance with electrical norms. The
power cable must be positioned so that no part of it reaches a temperature by 50°C. Before installation make
sure that the socket or switch used can be easily reached when the apliance is in place.
CAUTION: PRODUCER DECLINE ALL RFSPONSABILITY IF THESE SAFETY RULES ARE NOT
OBSERVED.
INSTRUCTION FOR USE
Description of controls (fig.2)
- I/O switch: pressing the switch, turns on or off the machine.
- Left button: pressing the left button parameters shift to the left.
- Right button: pressing the right button parameters shift to the right.
- Function buttons: pressing the function button you perform the various commands displayed:
Setting of machine
Switch on the machine: will be displayed the home page: time, date, program in use, vacuum time, sealing
time, button to select the type of work cycle MODE and button menu access ENTER (fig. 2).
From the home page, press the ENTER button, you enter the main menu of the machine from which you can
modify the parameters of the program in use or the settings of the machine.
From the home page, you can select the desired program from the 99 available by pressing the side buttons
left and right.
From the home page, press the MODE button, you can select the type of work cycle: automatic, manual and
vacuum in the containers.
Parameters of the program
= to enter;
= to exit;
= to decrease the value of the displayed parameter;
= to increase the value of the displayed parameter;
= to perform welding in advance (in automatic cycle); to perform welding (in the
manual cycle);
= to perform the STOP in advance;
= to select the type of work cycle: automatic, manual or container;
= to perform the departure of the vacuum cycle in the containers.
11