the area in which it is resting the mouth of the bag to perform the packaging. The movable part of the
decompression chamber is mounted on a movable lid connected to the structure by means of two hinges so
that they can be positioned on the mouth of the bag during processing.
THECNICAL DATA
The identification of the company selling the machine, in accordance with relevant legislation THROUGH
THE DOCUMENTS LISTED BELOW:
-
Declaration of Conformity CE
-
Instruction manual
A special plaque (Fig. 1) applied to the machine, reports indelibly information related to CE MARKING.
Not remove the label "CE" and / or exchange it with other plates.
If the label is accidentally for "CE" is damaged, separated from the machine or simply
removed the seal of the seller which binds to the same, the customer must inform the
home seller.
Power supply
Power
Vacuum pump
Sealing bar
Dimensions
Net weight
WARRANTY
The home seller undertakes, for a period of 12 months (twelve) from the date of shipment and direct delivery
of goods to the customer or dealer to ensure the proper functioning and the full compliance of the machines
the service for which they are intended.
The Manufacturer assumes no liability either direct or indirect deriving from:
-
failure to comply with the instructions contained in this manual;
-
use of the machine by personnel who has not read or fully understood the content of this manual;
-
use not complying to the specific norms currently applicable in the country of installation;
-
aspiration of foreign bodies or fluids;
-
unauthorized modifications and/or repairs;
-
use of not original accessories or spare parts;
-
exceptional events.
GENERAL SAFETY REGULATIONS
It is recommended, in particular, compliance with the following points:
-
never touch the metal parts of the packaging machine with wet hands;
-
do not pull the power cable or the appliance itself to remove the plug from the socket;
-
do not allow the packaging to be used by children or disabled, unattended electrical safety of this
appliance can only be guaranteed if it is correctly connected to an efficient earthing system, as
required by applicable electrical safety standards, it is necessary to verify this fundamental
requirement, and, in case of doubt, require an accurate control of the system by qualified personnel
and the dealer can not be held responsible for any damage caused by failure to earth the system;
-
in the case of possible damage to the grounding protection, the machine must be deprived in order
to avoid unwanted and / or unintended activation;
-
always use fuses comply with safety regulations, the correct value and mechanical properties
suitable;
-
the power cable of the packaging, it should be replaced in case of damage to the cable, or to replace
it, contact an authorized service center;
-
keep the cable away from hot parts;
-
always turn off and unplug the machine from the mains before you start any cleaning procedure;
-
clean coating machines, panels and controls, with soft rags and dry or slightly soaked in a non-
abrasive detergent solution or alcohol.
MVB330
230V/1N/50-60Hz
W
540
l/min
16
mm
330
mm
390 x 290 x 170h
kg
8,0
MVB430
230V/1N/50-60Hz
840
28
430
490 x 295 x 175h
10,5
10