Inserting The Accessories - ARTHUR MARTIN AKM5615PAX Benutzerinformation

The new default core temperature is
displayed during the next use of the core
temperature sensor.
When the meat is at the set core
temperature, the symbol for the core
temperature sensor
core temperature flash. An acoustic signal
sounds for two minutes.
5. Press any button or open the oven
door to stop the acoustic signal.
6. Remove the plug of the core
temperature sensor from the socket.
Remove the meat from the appliance.
7. Deactivate the appliance.
WARNING! Be careful when
you remove the tip and plug of
the core temperature sensor.
The core temperature sensor is
hot. There is a risk of burns.
Every time you put the core
temperature sensor in the
socket, you need to set the
core temperature time again.
You cannot select the duration
and end time.
When the appliance calculates
the provisional duration time for
the first time, the symbol
flashes in the display. When
the calculation ends, the
display shows the duration of
the cooking. Calculations run in
the background during the
cooking and the duration value
in the display is updated if
necessary.
You can change the temperature at any
time during the cooking:
1. Press :
• one time - the display shows the set
core temperature; if desired, it can
be modified within 5 seconds.
• two times - the display shows the
current oven temperature.
• three times - the display shows the
set oven temperature; if desired, it
and the default
can be modified within 5 seconds.
This info is available only during the
heating up phase.
2. Use the knob for the temperature to
change the temperature.

Inserting the accessories

Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
Deep pan:
Push the deep pan between the guide
bars of the shelf support.
Wire shelf and deep pan together:
Push the deep pan between the guide
bars of the shelf support and the wire shelf
on the guide bars above.
13