Connections, Operating And Display Elements - Cameo ZENIT W300 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1 3
1
POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100 - 240 V AC / 50 - 60Hz. Connection via supplied power cable (when
not in use, always close with rubber sealing cap).
2
POWER OUT
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all
connected devices does not exceed the value specified on the device in amperes (A) (when not in use, always close with the rubber sealing cap).
3
DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console. When not in use, always close with the rubber sealing cap).
4
DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with the rubber sealing cap).
5
OLED DISPLAY
Displays the current operating mode and other system settings.
6
TOUCH-SENSITIVE CONTROLS
MODE
Press mode to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER
Press ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm value changes by pressing ENTER.
UPand DOWN
Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to the value
of a menu item, such as the DMX address as required.
PRESSURE EQUALISATION ELEMENT
The pressure compensation element to prevent condensation forming inside the housing is located in the base of the device behind the
cable feed to the LED unit. In order to ensure its proper function, the element must be protected from contamination.
HOUSING FAN
The 2 housing fans and heat sink are located on the rear of the LED unit. In order to ensure good air circulation, do not cover the device and
clean it regularly.
PLEASE NOTE: In order to provide protection from spraying water, in accordance with protection class IP65, special IP65-rated XLR
connectors must be used correctly with the DMX input and output sockets, or they must be closed using the rubber sealing caps. When
connected correctly, or when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT sockets are protected from
spraying water according to IP65.
6 5 6
4 2
5