Cameo ZENIT W300 Bedienungsanleitung Seite 9

Color TEMPERATURE (Tunable White)
The color temperature mode enables you to configure the color temperature from cold white to warm white (CTC) and the brightness (Dim) of the
light directly on the device. Select the color temperature mode as per the procedure previously described in SETTING STAND ALONE MODE and
confirm with ENTER. Using the UP and DOWN controls, now select the menu item that you wish to edit (observe arrow) and confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to configure the desired value. Confirm with ENTER.
Press MODE three times to return to the main display (Mode Tunable White).
----------- Stand Alone -----------
Auto
Color Macro
Static
Tunable White
User Color
USER PRESETS (User color)
The operating mode "User Presets" allows you to store five individual color presets of overall brightness, strobe and a color mix of R, G,
B and W directly in the device. Select the "User Color" mode as per the procedure previously described in SETTING STAND ALONE MODE
and confirm with ENTER. Use UP AND DOWN to select one of the stored presets Color1 to Color5 and confirm with ENTER and select the
submenu item you want to edit (see arrows). Confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to set the value as required between 000 and
255. Confirm by pressing ENTER again. When all settings are configured as required, press MODE 4 times to return to the main display
(Mode User Color).
----------- Stand Alone -----------
Auto
Color Macro
Static
Tunable White
User Color
SLAVE MODE CONFIGURATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Slave" (observe arrow) and confirm with
ENTER. Connect the slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master unit
(Auto, Color Macro, Static, Tunable White, User Color). Now the slave unit will follow the master unit. If there is no control signal, the display
characters will flash. Flashing stops as soon as a control signal is present.
----------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Settings" (observe arrow) and confirm
with ENTER.
---------------- Menu -----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with UP and DOWN, confirm with ENTER,
change value or status with UP and DOWN, confirm with ENTER):
---------- Programme x ----------
Dim <100>
CTC <255>
Dim CTC
000 000
– –
100 255
------------ User Color ------------
Color1
Color2
Color3
Color4
Color5
Mode
Slave
Mode
Tunable White
------------ Color1 ------------ 000
Dimmer <255>
Strobe <255>
Red <255>
255
Green <255>
Blue <255>
White <255>
Mode
–
User Color
9